Safa Journal

If we subscribe to the Internet on a Vendor ISP we definitely get more than 2 Public IP. There are 4, 6 and so on depending on the size of our bandwiht lease. Well .. Also sometimes we only use 1 IP Public for the Internet, others are unemployed. In fact we can use for web servers, file servers, proxy servers and other another. Well for that the author tried to "sharing" of what writers do to be in oprek also by the other. This time the author combines the Mikrotik and Clarkconnect as a proxy.
Proxy Mikrotik ClarkConnect as a result oprek writer and has been running well. The result is increased upload bandwidth of about 100 Kbps 400kbps can achieve more. To be honest the author's own beginnings are also surprised by the speed test results showing increase upload. Surely this will affect the speed of the internet. After monitoring the course of both the OS was ClarkConnect store cache large enough so that they can leverage from Mikrotik proxy itself. So basically the cache stored in ClarConnect be taken by the mikrotik client when accessing the internet.
The authors use yan specifications are as follows:


1. ClarkConnect
    ü Intel P3 800Mhz Processor
    ü 100 GB Sata Hardisk
    ü 256 MB RAM
    ü 2 NIC 3com

2. Mikrotik RB450
 
Note: Specs above is an option, match with existing equipment
Actually, not too complicated if you are already familiar with the clarkconnect or mikrotik. This is a setting for beginners.

Here is his configuration scheme

His steps:

1. Attention, to display the IP address of the author is not here, because each administrator was aware of the Public IP, and IP local. With the guidance image above would be easy in the study and understood .. if not understand it must be understood ... Connect the cable from each Public IP eth0 to Public Switch, as well as the cable from eth1 IP Local Swithc respectively to Local.
2. Install Mikrotik (see Setup Mikrotik) make sure to run web-proxy Mikrotik, then DO NOT NEED the Nat Redirect Port because later will use the Parent Proxy ClarConnect.
3. Make sure it is with Mikrotik that you've set, the client can access the internet.
4. Next we ClarkConnect configuration.

Here the author uses ClarkConnect Community Edition 5. This version also has support SATA. For those not familiar with Clarkconnect please click www.clarkconnect.com and donwload version editionnya community. The point is that at the time of installation do not forget to check for squid web proxy also installed.